ASR-5300I Series Hardware User Manual
82
5.4
Replacing the Memory Module on RAID
Systems
The RAID controller comes with pre-installed DRAM module(s). Users may upgrade
or replace this module when the original module malfunctions (listed as an “NVRAM
failure” event in SANWatch).
Installing the DIMM Module
1.
Remove the controller module (refer to Replacing the Controller Module).
2.
Wait one minute for the remaining electricity on the main board to disperse.
3.
Push down the clips on the sides of the DIMM socket (indicated by the blue
circle). The DIMM will automatically eject from the socket.
Warning!
If installing or replacing only one DRAM module, with the I/O ports fac-
ing outwards, install the module into the DRAM slot on the right (blue
slot).
Follow the ESD precautions (refer to ESD Precautions).
Contact your system vendor to select a compatible DRAM module.
Reusing the DRAM module removed from a failed controller is not
recommended unless you have a similar RAID system to test its integrity.
DRAM location
Removing the module
Summary of Contents for ASR-5300I Series
