ADT Enterpreneur 3000EN, Installation And Setup Manual

Page: 39 / 104

4-5
*55
Dynamic Signaling Priority
0 = Primary dialer first / AAV via phone
line
1 = Communication Device (LRR) first /
AAV via communication device
path (see AAV Path Select
paragraph at right)
UL Installations: For UL Commercial
Burglary installations that use a DACT
and LRR, the DACT must be
programmed for priority (option “0”).
This field selects the primary communication path for
reporting (dialer or communication device) of primary phone
number events (see
∗
49 Split/Dual Reporting) and selects the
communication path used for AAV sessions (phone line or
communication device path). Use
∗
29 IP/GSM menu mode to
enable the communication device being used.
For Dynamic Signaling Priority:
Select the initial
reporting destination for messages as follows:
Primary Dialer First selected ( 0 ):
•
If acknowledged before delay expires (see
∗
54), then
message will not be sent via LRR.
•
If not acknowledged before delay expires, message is sent to
both the Primary Phone No. and via LRR.
Communication Device (Long Range Radio) First selected ( 1 ):
•
If acknowledged before delay expires, then message will not
be sent to the primary dialer.
•
If not acknowledged before delay expires, message is sent to
both the Primary Phone No. and via LRR.
For AAV Path Select:
•
If using the UVS system or AVS system with non-ECP
connection, option 0 must always be used.
•
If using the AVS system with ECP connection, either option
(0 or 1) may be used, but note the following:
IMPORTANT: If option “1” is selected, a 2-way voice (AAV)
device compatible with the communication device path must
be used (ex. GSMV-ADT communicator). When selected, AAV
sessions
always occur via the GSMV-ADT communicator,
even if reporting reverts to phone line backup due to GSMV-
ADT communicator path reporting failure.
*56
Zone Programming Menu Mode Use this menu mode to program zone information. See Zone
Programming section for procedures.
*57
Function Key Menu Mode Use this menu mode to program touchpad function keys. See
Function Key section for procedures.
*58
Expert Zone Programming Menu
Mode This menu mode can be used to quickly program zone
information, but is recommended only for those already
familiar with *56 menu mode. See Zone Programming section
for procedures.
System Status Report Codes (
∗∗∗∗
59–
∗∗∗∗
68)
Zone report codes are programmed using interactive
✱
56 or
✱
58 Zone Programming modes, while system status
(non-alarm) codes and restore codes are entered in the following data fields.
UL installations: Program fields *59 - *76 as required by the applicable UL Standards shown in each field’s
description.
Contact ID® Reporting: Enter any digit (other than “0”) in the first box to enable the zone to report. Entries
in the second boxes are ignored.