Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Software Reference Manual, Page: 91 / 233

5-52
container Commands
Use the
container list
command after using the
container
extend volume
command to display information about the
volume set after you extend it, as in the following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
E: 1 Volume 164MB NTFS 2:02:0 200MB: 100MB
2:00:0 64.0KB: 32.0MB
2:01:0 64.0KB: 32.0MB
The following list describes the change to the display as the result of
extending a volume set with the
container extend volume
command:
■
The Total Size column displays a new size, taking into account
the value(s) specified for the
free_space
parameters. In the
example the new size is 164 MB.
■
The Usage column continues to display NTFS, indicating that
array 1 has an NTFS file system on it.
■
The Scsi C:ID:L column displays the SCSI ID for the disk on
which the original volume set was created. It also displays the
SCSI ID(s) for the disk(s) from which you specified the
freespace. In the example, these disks are 2:00:0 and 2:01:0.
■
The Partition Offset:Size column displays the partition
offset(s) and size(s) for the partition(s) associated with the
extended volume set. In the example the partition offsets and
sizes are 64.0 KB and 32.0 MB.
If a partition is dead, the “:” (colon) in the Partition Offset:Size
column changes to a “!” (exclamation point). See the
disk
remove dead_partitions
( page 7-9 )
command for
more information on dead partitions.