Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Software Reference Manual, Page: 117 / 233

5-78
container Commands
Parameters
{container}
Specifies the ID number (0 to 63) of the array you want to
reconfigure.
{scsi_device}...
Specifies one or more devices. Typically, you specify one or
more devices when adding more drives to an array or moving
an array’s partitions. A SCSI ID consists of a SCSI channel
number (for example, 0, 1, 2, 3, etc.), a SCSI device ID (0
through 15 inclusive), and a SCSI device logical unit number (0
through 7 inclusive). See the
scsi_device
section on
page 3-7 for more information on how to specify the SCSI
device. The command uses the freespace(s) from the SCSI
device(s) you specify to reconfigure the array.
Switches
/stripe_size{=integer}
Specifies the changed stripe size for the array. You can specify
stripe sizes for the following types of arrays:
■ RAID-5 set
■ Multilevel stripe set:
– Stripe set of mirror sets
– Stripe set of volume sets
– Stripe set of stripe sets
/extend_fs{=boolean}
Specifies whether to extend the file system so that it occupies
the entire reconfigured array. If you specify
TRUE
, the
command adds no new freespace and extends the file system
so that it occupies the entire reconfigured array. (The command
extends the file system after completing the reconfigure
operation.) If you specify
FALSE
, the command adds freespace
to the reconfigured array and does not extend the file system to
occupy the entire reconfigured array.
This switch defaults to
FALSE
.