Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Software Reference Manual, Page: 154 / 233

5-115
container Commands
Use the
container list
command after using the
container
split
command to display information about the split mirror set,
as in the following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB
1 Volume 10.0MB NTFS 0:02:0 10.0MB: 10.0MB
The following list describes the change to the display as the result of
splitting a mirror set with the
container split
command:
■ The Num Label column displays the IDs (in the example, 0
and 1) of the split mirror set. array 0 is the master array; array 1
is the split array.
This column also displays the label(s) assigned to the array(s)
when the array(s) was created. If no label(s) was assigned to
the array(s) then no label(s) appears in the column.
On UNIX systems, the root special file associated with the
array also appears in this column.
■ The Type column displays Volume as the array type for a split
mirror set.
■ The Usage column displays NTFS to indicate that file systems
exist on both arrays. You can create an NTFS or FAT file system
on an array by using the
container format
command.
■ The Scsi C:ID:L column displays the SCSI device IDs for the
disk on which the split mirror set (now two volume sets)
reside. In the example, the SCSI device ID is 0:02:0.
■ The Partition Offset:Size column displays the partition offsets
and sizes for the partition associated with the split mirror set
(now two volume sets).
If a partition is dead, the “:” (colon) in the Partition Offset:Size
column changes to a “!” (exclamation point). See the
disk
remove dead_partitions
( page 7-9 )
command for
more information on dead partitions.