Actidata actiNAS cube RDX, User Manual

Page: 128 / 168

/ actiNAS Manager · System
128
UPS
Use the settings here to configure the UPS.
Enable Use the option to enable or disable UPS support for serial port.
Serial Port Use this option to select serial port option (com1 or USB).
Service Use this option to select the type of UPS, whether UPS (smart) or Dumb UPS.
UPS Vendor Use this option to select the UPS vendor. Currently, only APC and Beam-Tech UPS models
are supported.
Cable Model Use this option to select the UPS cable type. Options are: simple, smart, ether, and usb.
Shutdown Delay (Min) Use this option to set the delay time in minutes before UPS shutdown. Delay Time has
expired.
Reset Use this button to undo or clear any changes made.
Apply Use this button to save the changes made.
Note: In NAS models with com2 serial port, com2 is reserved for SES use.
Note: Users/ customers must use only the supported UPS vendor models: APC and Beam-Tech. If others UPS
models are used, there is no guarantee that the NAS will be able to communicate to the UPS. The basic UPS
function (to provide uninterrupted power supply to the NAS) will probably work but the shutdown delay might not
work using the UPS cable from the “unsupported” UPS vendor model. Other UPS vendor models will be added to
the approved model in the future,
Note: For most cases, it is recommended to use as a value of 1 instead of 0 (zero) in shutdown delay. When set
to 0, the timer is disabled and the UPS will shutdown the NAS depending on the battery level and / or remaining
runtime, or when the UPS battery is exhausted. However, some types of UPS cables, which do not support low
battery detection, might not work when shutdown delay is set to 0