Actidata actiNAS cube RDX, User Manual

Page: 85 / 168

85
Network · / actiNAS Manager
Network Adaptor Configuration Options
Device Shows the network device name. eth0 is the device name for LAN0 gigabit port.
IP Shows the current IP address of the network device. Configure the IP address as necessary.
Gateway Show the current IP address of the Gateway. To edit, enter the Gateway IP address
Subnet Mask Shows the current subnet mask setting. To edit, type in the new subnet mask number.
MTU The MTU size (Maximum Transmission Unit) in bytes. To modify the MTU size for this
interface, select the new MTU size. Options are: 1500 (default), 2000, 3000, 4000, 5000,
6000, 7000, 8000, and 9000.
MAC address Shows the MAC address of network device.
Enable on Boot If enabled, this adapter will be active when actiNAS starts up
Dynamic IP
(BOOTP/DHCP)
If checked, this specifies that this network device will dynamically obtain an IP address from
a Dynamic Host Configuration Protocol (DHCP) server or from a Bootstrap Protocol
(BOOTP) server
Default Gateway If checked, the default gateway will be enabled in this adapter. A default gateway is a local IP
router that is used to forward packets to destination beyond the local network. Only one
default gateway in the NAS can be enabled in a certain time.
Reset Use this button to undo or clear any changes made.
Apply Use this button to save the changes made.
Create Trunking Use this button to configure network trunking.