Actidata actiNAS cube RDX, User Manual

Page: 10 / 168

/ /Introduction · Technical Specifications
10
Technical Specifications
Hardware Platform

Intel Celeron 1.6G CPU (or above)

Cache memory: 1GB ~ 2GB DDR2-667MHz

Supports 5 SATA II 2TB hard drives

Two Gigabit Ethernet port

Environmental monitoring unit

270W power supply with PFC
Storage
Equipped with software RAID function to offer fault
tolerant data protection

Supports RAID levels 0, 1, 5, 6, 10, Linear

Volume Management

Disk usage statistics

Hot spare capability
General

Supports Volume as iSCSI Target

File Server Independent

Peer-to-peer operation

Localized language support

With Quick Setup function

Supports trunking / load balance / fail over /
LACP(802.3ad)

Support UPS monitoring
Macintosh Support

AFP over AppleTalk

AFP over TCP/IP

Mac Zone

iTunes service
Connectivity

SMB over TCP / IP

NFS over UDP / IP

CIFS over TCP / IP

NAT

DHCP

FTP

Internet Server

Unit acts as a DHCP server

Unit act as a master browser

Share level security

User ID security for NFS
System Management

Automatic IP address configuration

Self-contained unit; no extras needed

Management through Web browser

Flash upgradeable unit

Supports Microsoft ADS/PDC and Unix NIS accounts
import

Fail-free online firmware upgrade

Unicode support
RAID Levels
Below is the list of RAID Levels available for configuration in the NAS.
RAID Level
No. of Allowed
Failed Drives Description Min. Required No. of Drives
0 None Block striping is provided and yields higher performance than with individual drives. There
is no redundancy.
1
1 1 Drives are mirrored. All data is 100% duplicated on an equivalent drive. Fully redundant. 2
5 1 Data is striped across several physical drives. Parity protection is used for data
redundancy.
3
6 2 Data is striped across several physical drives, just like in RAID 5, and a second set of parity
is calculated and written across all the drives. RAID 6 provides for an extremely high data
fault tolerance and can sustain multiple simultaneous drive failures.
4
10 2 Striping over two RAID1 RAID sets. This level provides mirroring and redundancy through
striping.
4
Linear
(JBOD)
None Linear (JBOD) is similar to RAID 0 in that it concatenates the capacity of all member drives.
The data is written linearly starting with the first disk drive. When first disk drive becomes
full, the next disk drive is used. Linear can have 1 or more disk drives. There is no data
redundancy.
1