Changing network settings
37
Scanning for connected devices
First ensure that you have connected the SREA-01 units you want to install on the
same Ethernet network as the PC is connected to. Use standard Ethernet cables,
straight-through or crossover cable depending on how you connect to the device.
See chapter
for more details.
When the ABB IP Configuration Tool is started, it will scan the Ethernet network for
SREA-01 devices. All detected devices will be presented in a list in the main window.
If you want to force a new scan for devices, you can press the ‘Scan’ button.
Note:
Some software firewall applications block the network packets sent or
received by the IP Configuration Tool. If this happens, you may need to disable your
software firewall temporarily. Be sure not to connect to an insecure network while
operating without a firewall application.
IP
The IP address of the SREA-01 unit
SN
The subnet mask
GW
The default gateway
DHCP
Dynamically assigned IP address On/Off
Version
Firmware version of the module
Type
Product type (SREA-01)
MAC
The Ethernet MAC address (unique for each unit, printed on the
side label)
Summary of Contents for SREA-01
