ABB SREA-01, User Manual

Page: 81 / 106

Configuration pages
81
Optional image of drive installation – This field can be used to upload a picture to
the Drive Information page. To upload the picture, press ‘Browse’, select the image
and press ‘save settings’. To remove the image, the ‘delete image’ can be used.
Template – This dropdown box is used to select the drive type and mode. Usually
the model is detected by the automatic detection procedure. If you are unsure about
the mode of your drive, see group 99. For example, the template ACS550 (Vector)
should be used if you have an ACS550 and the parameter 99.04 MOTOR CTRL
MODE is either 1 VECTOR: SPEED or 2 VECTOR: TORQ.
Modbus/TCP server IP address – If the drive is connected to SREA-01 by
Ethernet, enter its IP address in this field. If you are using serial Modbus to connect
to the drive, leave the field blank.
Modbus/TCP server port – If the drive is connected to SREA-01 by Ethernet, enter
its Modbus port in this field. Usually the port is 502.
Modbus Slave Address – Enter the node address of the drive here. Usually, but not
always, the node address can be found in groups 52 or 53, depending on the drive
model and the configuration.
Device specific alarms – Device specific alarms are default alarms that can be sent
if the drive is disconnected from SREA-01 or if its status is FAULT or WARNING/
ALARM. If you check the alarms, they are monitored and reported. If you clear the
checkboxes, they are ignored. You can use the check and clear buttons to check or
clear all alarms. For more information about alarm classes, see section
Alarm on
page 84 .
Pages
Pages are custom views of drive parameters and actual values. Each custom view
can show 20 freely selectable values and there can be several custom pages. A
custom page can also be selected as the start-up page of the SREA-01 user
interface.
To access the Pages configuration, select Configuration – Pages. The following view
will be opened:
The ‘start page’ button can be used to select the page as the page that is shown
when the user logs in to SREA-01. The ‘clear start page’ button can be used to use