Configuration pages
80
Note:
The automatic detection procedure leaves the previously configured drives
intact. For example, if there is a drive with address 5 on the list but the actual drive
has been removed from the network, the automatic detection procedure does not
remove the drive from the list.
Not all drives can be found or identified automatically. For example, ACS800 drives
can be found but they can not be identified. After the scanning procedure finishes,
you have to select the templates manually for them. To do that, access the Device
properties page by pressing the ‘edit’ button. The Device properties page can also
be used to add additional information to the drive:
Name
– The name of the drive. By default the drives are named by their templates
and Modbus addresses.
Disable device
– A device can be disabled in case the device is switched off
temporarily. In case the device is disabled, it is not monitored by SREA-01 or listed in
drive summary page. No alarming is active regarding the disabled device. The
device remains in devices list with indication that device is disabled.
More information
– This field can be used to write additional information on the
Drive Information page of the drive.
Summary of Contents for SREA-01
