User interface
52
You can change the value of the parameter either by writing the new value to the
value field or by selecting the new value from the drop-down menu. After changing
the value, press the ‘set’ button to commit the change to the drive.
When the ‘set’ button is pressed, the drive starts using the new value immediately.
The new value is, however, not stored to the permanent flash memory of the drive.
The ‘save to flash’ button on the bottom of page can be used to save the values to
the permanently. After it has been pressed, the new values will be kept even after
the drive has been powered off.
The upload configuration button can be used to read the complete parameter
configuration from the drive to the PC. The parameters are saved in a tab-delimited
plain text file. Example of a parameter file:
[SREA-01 Report File]
2008-06-02 09:19:19
ACS350 (Scalar) (1)
ACS350 (Scalar)
Group 01: OPERATING DATA
NAME
VALUE
01.02: SPEED [rpm]
0
01.03: OUTPUT FREQ [Hz]
0.0
01.04: CURRENT [A]
0.0
01.05: TORQUE [%]
0.0
01.06: POWER [kW]
0.0
01.07: DC BUS VOLTAGE [V]
330
01.09: OUTPUT VOLTAGE [V]
0
01.10: DRIVE TEMP [°C]
37.9
01.11: EXTERNAL REF 1 [Hz] 0.0
Summary of Contents for SREA-01
