ABB RED670 Relion 670 series, Commissioning Manual

Page: 79 / 308

Section 9 Establishing connection and verifying the
IEEE C37.118/1344 communication
9.1 Overview
GUID-EFD77C28-6F7C-4277-8C7E-30E78CC8EFAD v3
The IED can support synchrophasor data communication via IEEE C37.118 and/or
IEEE1344 with maximum 8 TCP clients and 6 UDP client groups, simultaneously.
The rear OEM ports are used for IEEE C37.118/1344 communication. The same
ports can also be used for substation bus (IEC 61850-8-1) communication and
process bus (IEC/UCA 61850-9-2LE) communication where applicable.
In order to establish a connection between PMU and a TCP/UDP client (PDC
client), an Ethernet communication link (e.g. optical fiber) shall be available and
the required parameters on both PMU and the TCP/UDP client shall be set. For the
purpose of this section, an Open PDC tool (PMU Connection Tester) installed on a
PC is used as the TCP/UDP client.
9.2 Setting the PMU station communication (PMU
Report)
GUID-B8DCD7BA-AEBA-4977-89D4-2F18ECE34A2F v1
1. Check the settings for the PMU Report parameters by navigating to: Main
menu/Configuration/Communication/Station communication/phasor
measurement/PMU Report/PMUREPORT:1
1.1. Make sure that the operation of at least one PMU instance (e.g. PMU1)
is On .
1.2. Enable sending the frequency data by setting the parameter
SendFreqInfo to On .
2. Check the operation of the required phasor channels (PHASORREPORT) by
navigating to:
Main menu/Configuration/Communication/Station
communication/phasor measurement/PMU Report/PHASORREPORT:x .
1MRK 505 378-UEN A
Section 9
Establishing connection and verifying the IEEE C37.118/1344 communication
Line differential protection RED670 2.2 IEC 73
Commissioning manual