ABB i-bus KNX JRA/S 6.230.3.1, Product Manual

Page: 63 / 152

ABB i-bus
®
KNX
Commissioning
JRA/S 6.230.3.1 | 2CDC506083D0201 61
Feedback via group object
"Move to position"
Options: No
Yes
This parameter defines whether the Move to position [0…255] group object sends a status response.
•
Yes : The following parameter appears:
Send object value
Options: No, update only
On change
After request
After a change or request
•
No, update only : The status is updated but not sent.
•
On change : The status is sent when a change occurs.
•
After request : The status is sent when a request occurs.
•
After a change or request : The status is sent when a change or request occurs.
Extra feedback
Options: None
End positions
Status byte
An additional status response can be enabled with this parameter.
•
None : There is no feedback.
•
End positions : Enables the group objects Status Lower end position and Status Upper end position ,
which indicate that the shutter/blind is in the upper or lower position (measured based on total travel
time).
•
Status byte : This enables the group object Status byte . This contains further information in coded
form.
The following parameters appear when End positions or Status byte is selected:
Send object value
Options: No, update only
On change
After request
After a change or request
•
No, update only : The status is updated but not sent.
•
On change : The status is sent when a change occurs.
•
After request : The status is sent when a request occurs.
•
After a change or request : The status is sent when a change or request occurs.