ABB i-bus KNX JRA/S 6.230.3.1, Product Manual

Page: 28 / 152

ABB i-bus
®
KNX
Commissioning
26 2CDC506083D0201 | JRA/S 6.230.3.1
Feedback via group objects
"Move to position/slat"
Options: No
Yes
This parameter defines whether the group object Move to position/Adjust slat [0…255] sends a status
response.
•
Yes : The following parameter appears:
Send object value
Options: No, update only
On change
After request
After a change or request
•
No, update only : The status is updated but not sent.
•
On change : The status is sent when a change occurs.
•
After request : The status is sent when a request occurs.
•
After a change or request : The status is sent when a change or request occurs.
Extra feedback
Options: None
End positions
Status byte
An additional status response can be enabled with this parameter.
•
None : There is no feedback.
•
End positions : This enables the group objects Status Lower end position and Status Upper end
position. These indicate that the blind is in the upper or lower position (measured based on total travel
time).
•
Status byte : This enables the group object Status byte. This contains further information in coded
form.
The following parameters appear when End positions or Status byte is selected:
Send object value
Options: No, update only
On change
After request
After a change or request
•
No, update only : The status is updated but not sent.
•
On change : The status is sent when a change occurs.
•
After request : The status is sent when a request occurs.
•
After a change or request : The status is sent when a change or request occurs.