ABB DressPack IRB6650S, Product Manual

Page: 343 / 390

Note Action
Fit the two attachment screws securing the mount-
ing bracket (or brackets). 2
Fit and tighten the locking nut (or nuts). 3
Fit the Pushlok nipple (or nipples). 4
Tightening torque, brass coup-
lings 1/2": 31 Nm Connect the Proc 3 hose from the Water and Air
unit.
CAUTION
Do not tighten the brass couplings for water and air
with excessive force.
5
Tightening torque, brass coup-
lings 1/2": 31 Nm Connect the Proc 4 hose from the Water and Air
unit.
CAUTION
Do not tighten the brass couplings for water and air
with excessive force.
6
Only if the option Second water
return has been selected.
Only if the option Second water
return has been selected.
Tighten the locking nut, at the shop floor side. 7
Connect the hose of the shop water drain to the
water-return circuit. 8
Turn on the water supply to the Water and Air unit. 9
Activate the electrical valve. 10
This is done in order to evacuate
all air in the circuit. First turn on and then turn off the shop water drain. 11
Tighten if there is any leakage. Wait a couple of minutes and check for leakage. 12
Turn on the shop water drain. 13
Product manual - DressPack/SpotPack IRB 6650S 343
3HAC055424-001 Revision: C
© Copyright 2004-2018 ABB. All rights reserved.
4 Repair
4.4.3 Replacement of Water-return circuit
Continued