ABB ACS560, Quick Installation And Start-Up Manual

Page: 6 / 306

￭
Removing drive from the DIN installation rail (frames R0...R2 only)
To remove the drive, open the locking part using a flat-head screwdriver.
￭ Installing a drive with screws (frames R0...R8)
All drives of frames R0...R8 can be installed on a wall with screws. See the required
screw sizes in below mounting dimensions table. See also
Dimensions, weights
and free space requirements (page 132)
WARNING!
The drive module (frames R6...R8) is heavy (45 to 70 kg). Consider the
following:
• Use a suitable lifting device.
• Do not lift the module manually.
• Make sure that the wall and the fixing devices can carry the weight. See
data in the table below.
1. Mark the mounting hole locations using the mounting template included in
the package.
Mounting dimensions Mounting template
R8 R7 R6 R5 R4 R3 R2 R1 R0 Frames
M8 M6 M5 Screws
(mm)
1
658 583 531 581 619 473 191 a
701 623 571 612 - b
263 245 213 160 148 75 50
- 75 d
200 75 e
70.0 55.0 45.0 28.0 23.0 14.86 7.54 4.57 4.47 Weight
(kg)
2. Drill the mounting holes.
3. Tighten the screws into the mounting holes.
4. Position the drive onto the screws on the wall.
5. Tighten the mounting screws.
6 EN - Quick installation and start-up guide
EN
HI