ABB ACS560, Quick Installation And Start-Up Manual

Page: 161 / 306

What to do Cause Fault / Aux.
code aux code
visible only on
assistant con-
trol panel and
drive com-
poser)) Code
(hex)
SSW runs in partial functionality
mode. A fatal error in the power-
up phase of System Soft-
ware (SSW). Internal SSW
fault 64B1
5 - Initializing WoRm volumes failed 1 - Starting OS time tick failed
6 - Loading FPGA configuration failed 2 - Creating system tasks failed
7 - Loading application program failed 3 - Initializing file system failed
4 - Checking file system failed
Make sure a valid user parameter
set exists. Reload if uncertain. Loading user parameter
set failed. User set fault 64B2
Macro parameterization
failed, eg. Parameter de-
fault value that cannot be
changed has been attemp-
ted to write. Macro paramet-
erization error 64B3
Reboot the control unit using para-
meter 96.08 Control board boot or
by cycling power. If the problem
persists, contact ABB. Operating system error.
Note: This fault cannot be
reset. Kernel overload 64E1
Try forcing a save using parameter
96.07 Parameter save manually. Parameter load or save
failed. Parameter sys-
tem 6581
Check panel or PC-tool communica-
tion and if it is still in backup or re-
store state. During backup creating or
restoring operation a
panel or PC-tool has failed
to communicate with the
drive as part of this opera-
tion. Backup/Restore
timeout 6591
Check PLC programming.
Check parameter groups 50 Field-
bus adapter (FBA) and 51 FBA A
settings. Requested functionality is
not activated. FBA A parameter
conflict 65A1
Diagnostics 161
EN
HI