ABB ACS560, Quick Installation And Start-Up Manual

Page: 159 / 306

What to do Cause Fault / Aux.
code aux code
visible only on
assistant con-
trol panel and
drive com-
poser)) Code
(hex)
Contact ABB. Duplicated measurements
are beyond limits. Redundant
measurement 5095
Contact your local ABB representat-
ive. Excessive hardware tem-
perature. Overtemperat-
ure hw 5096
Try resetting the fault or cycle the
power to the drive. Communication failure to
standard I/O. I/O communica-
tion loss 5098
Check connections and parameter
95.04 Control board supply. Communication errors
between drive control unit
and power unit. PU communica-
tion 5681
Check connections. Connection lost between
drive control unit and
power unit. Power unit lost 5682
Contact ABB. Internal communication
error. PU communica-
tion internal 5690
Contact ABB. Measurement circuit fault. Measurement
circuit ADC 5691
Contact ABB. Power unit power supply
failure. PU board power-
fail 5692
Contact ABB. Measurement circuit fault. Measurement
circuit DFF 5693
Configure the power units. Configured power units
not found. Reduced run 5695
Check feedback signal from char-
ging system Charging feedback signal
missing. Charging feed-
back 5697
Check the logic and software com-
patibility. The power unit logic gen-
erated a fault which is not
known by software. Unknown PU
fault 5698
Check fan operation and connec-
tion.
Replace fan if faulty. Cooling fan stuck or dis-
connected. Fan 50A0
Reboot the control unit with para-
meter 96.08 Control board boot or
by cycling power. If the problem
persists, contact ABB. Firmware and FPGA ver-
sions are incompatible. FPGA version in-
compatible 6181
Diagnostics 159
EN
HI