ABB ACS 1013-A1, User Manual

Page: 123 / 186

09 OPERATION
3BHS213401 E01 REV H ACS1000 AIR-COOLED USER MANUAL 121/184
9.7 Starting the drive
9.7.1 Checks before starting the drive
▲
DANGER
⚠
When the drive is put into service after it has been commissioned, or after it has been taken
out of service for a longer period, use the following checklist:
9.7.2 Starting the drive remotely
When the drive is operated from remote through a higher-level control system or an operator
control desk, follow the instructions in the appropriate manuals.
9.7.3 Starting the drive locally
1. Enable the local control mode of the drive.
2. Check that no alarm or fault messages are displayed on the CDP control panel.
- If a fault message is displayed on the CDP control panel, reset the fault.
It is recommended to have the following documents at hand when starting the
drive locally for the first time after commissioning:
- “Appendix D – Wiring diagrams” to identify the circuit breakers to be
switched on
- “10 CDP control panel” on page 127 for information on functions and features of
the CDP control panel
Hazardous voltages!
- All covers must be screwed in place to prevent unintentional contact with
energized components.
1.
Tools and foreign objects are inside the cabinet.
□
2.
All auxiliary power supplies from external sources are switched on.
□
3.
All internal circuit breakers of the drive are closed.
□
4.
All covers are mounted and the doors are closed, locked or bolted.
□
5.
Grounding switch is in the ungrounded position.
□
6.
MCB is in operating position.
□
7.
No run interlocks are active.
□
LOC RESET REF
REM