3M Unitek Ortholux Luminous Curing Light, Instructions For Use Manual

Page: 7 / 136

6 English
ENGLISH
Insert the battery:
• Remove the protective cap from the battery
and keep with the unit packaging.
• Slowly insert the battery with the thread side
towards the metal housing into the handpiece
until it stops. Screw the battery clockwise by hand
until the seal is pressed firmly against the metal
housing. The unit will not function properly if the
battery is not screwed in completely!
• If the unit does not function properly, remove
the battery and reinsert it as described above.
Power Level Display of the Handpiece
Battery Charging
• The unit contains a powerful lithium-ion
rechargeable battery. The battery does not have
any memory effect and can therefore be recharged
at any time by placing it in the charger (see
“Power Level Display of the Handpiece” below).
• Alternatively, the battery in the unit can be
replaced by a spare battery (available separately)
which has been charged.
• Place the handpiece on the charger for approximately
1.5 hours before the first use, in order to charge the
new battery completely for the first time.
- The status LED showing the operating status of
the charger flashes green during the charging
operation; see below “Operating Status Display
of the Charger.”
Operating Status Display of the Charger
Status LED
showing operating
status
Power Level LED
Seal
Status LED Operating status
Handpiece/battery outside the charger Handpiece/battery in the charger
Steady green light Charger ready for operation Charging has been completed
Flashes green n/a Battery is being charged
Steady red light Charge contact pins are wet Charge contact pins are wet
Flashes alternately red and green Malfunction in the charger Problem during charging
Power Level LED Operating status
Handpiece outside the charger Handpiece in the charger
Steady green light Battery is charged, handpiece ready for operation Not possible, handpiece is in sleep mode
Steady red light Warning for low battery capacity, remaining capacity
adequate typically for 20 3-second cycles
Not possible, handpiece is in sleep mode
Flashes red Battery fully discharged, exposure cycle will be
completed or, if in extended mode, stopped
Problem in charging, battery is defective or
cannot be charged