3M Unitek Ortholux Luminous Curing Light, Instructions For Use Manual

Page: 5 / 136

4 English
ENGLISH
Light guide
Handpiece
Charger
Power cord
Eyeshield
Product Description
Ortholux Luminous Curing Light, is a high-
performance light source for intraoral polymerization
of orthodontic adhesives. It consists of a charger and
a cordless handpiece powered by a rechargeable
battery. The device is a medical electrical device in
accordance with IEC 60601-1 and is available as a
tabletop device. Wall mounting is not possible.
The light source is a high-performance light-emitting
diode (LED). The emitted light covers the light
wavelengths between 430 and 480 nm.
Settable exposure times:
• 3, 6, 9, or 12 seconds.
• Extended mode (15 seconds)
• Tack cure mode (1 second)
The charger is equipped with an integrated light
intensity testing area.
The unit is shipped with an 8 mm diameter light
guide. It is not permissible to use light guides from
other manufacturers.
The handpiece is equipped with a sleep mode to minimize
the unit’s energy consumption. The handpiece switches
to sleep mode once it is placed in the charger or if left
unused for approximately 5 minutes outside the charger.
NOTE: Do not discard these Instructions for the
duration of product use.
Intended Use
• Ortholux Luminous Curing Light is intended for
the polymerization of light-curing orthodontic
adhesives with photoinitiators in the wavelength
range of 430-480 nm.
The high intensity light output of the Ortholux
Luminous Curing Light allows for fast curing
times. Refer to the table under Recommended
Cure Techniques with 3M Unitek Adhesives.
- Though the majority of light-curing orthodontic
adhesives are responsive in this range of
wavelengths, you may wish to contact the
manufacturer of the material in question.
• Ortholux Luminous Curing Light is not intended
for use with dental adhesives or other light curing
procedures in a dental office.
Technical Data
Charger
Operating voltage: 100-127 V 50/60 Hz
230 V 50/60 Hz (see rating
plate for factory-set voltage)
Power input: Nominal consumption
0.08 A (230 V)
0.16 A (100-127 V)
Dimensions: Length: 170 mm
Width: 95 mm
Height: 50 mm
Weight: 650 g