ZyXEL Communications XGS4600 Series, Руководство пользователя

Страница: 588 / 645

Chapter 69 Configure Clone
XGS4600 Series User’s Guide
588
The following table describes the labels in this screen.
Table 284 Management > Configure Clone
LABEL DESCRIPTION
Source/
Destination In stacking mode, a port is defined by a slot ID representing the Switch in the stack and a port
number.
Select the source port and slot (in stacking mode) under the Source label. This port’s attributes are
copied.
Enter the destination port or ports under the Destination label. These are the ports which are going
to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a hyphen. For example,
2, 4, 6 indicates that ports 2, 4 and 6
are the destination ports. 2–6 indicates that ports 2 through 6 are the destination ports.
In stacking mode, you can select multiple destination slots.
* Select * to apply all settings to the port. Use this first to select the common settings and then
remove the settings you do not want copied.
Basic Setting Select which port settings (you configured in the Basic Setting menus) should be copied to the
destination ports.
Advanced
Application Select which port settings (you configured in the Advanced Application menus) should be copied
to the destination ports.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.