Zontes ZT350-V1, Руководство по обслуживанию

Страница: 89 / 120

7
、
FRONT FORK COMPONENT
88
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
2 1251111-006000 ZT310-R double head screw 2
3 1274200-018000 ZT310-R gasket of upper connecting board 4
4 1244200-008000 ZT310-R buffer rubber of upper connecting board 4
5 4094300-001051 ZT350-R upper connection board (dark gray matte) 1
6 1251700-065000 ZT310-R bushing φ10×φ12×41 2
7 1251300-057093 Non-standard nut M10×1.5(Dacromet) 2 40N.m
9 1250105-280000 GB5789 M10×1.25×60 (level 10.9 dacromet) 2
New model:
Old model:
1 4094300-004051
ZT310-V direction handlebar pad M12×1.25(dark gray
matte/spray paint)
2
4094200-008051
ZT310-V direction handlebar pad M10×1.25(dark gray
matte/spray paint)
2
PROCEDURE:
●
Uplink plate and spacer assembly
In order to facilitate the direction of the block, the direction and the upper block should be assembled first to
prevent the block from rotating during the disassembly process. The direction should be wrapped with cotton
or other soft materials to prevent scratching the paint surface.
Old model:
Remove nuts
⑺
with a 14# sleeve,remove the gasket
⑶
, cushion rubber
⑷
, and bushing
⑹
.Remove the upper
plate
⑸
.
If you need to replace the double studs separately, you can lock the two M10×1.5 nuts to each other as
shown in the small figure and then use the sleeve to turn clockwise to remove the studs. When replacing a
new stud, you must apply a threaded fastening to prevent loosening. It is necessary to ensure that the
assembly is in place and firm, and we are not responsible for any damage caused by improper assembly.
The spacer
⑴
, the upper clamp and the direction handle are disassembled.
New model:
Remove bolts
⑼
with a 14# sleeve,remove the gasket
⑶
, cushion rubber
⑷
, and bushing
⑹
.Remove the upper
plate
⑸
.Remove the upper plate
⑸
.
CAUTION:
●
Protect protective measures to prevent scratching the appearance of parts.
●
When reassembling, it is necessary to use the direction to ensure that the center and direction of the
spacers on both sides are coaxial with the center. First install 4 pieces of cushioning rubber into the upper
plate and then install the bushing separately. Make sure that the bushing is flush with the cushioning rubber,
otherwise it should be reassembled. When tightening the nut, ensure that the torque is 40N.m. Check the
buffer for spillage and reassemble if necessary.
8
Fig.28 FRONT FORK
COMPONENT
Uplink plate, direction handle block component