Zontes ZT350-V1, Руководство по обслуживанию

Страница: 21 / 120

3
、
INTAKE SYSTEM COMPONENT
20
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 3
2 1050961-004000 Air filter intake air temperature sensor 1
3 1274200-088000 ZT310 water pipe clamp(φ10.5) 5
4 1244200-095000 ZT310-V canister tube adsorption (Φ5 x Φ 11) 1
5 1051371-002000 Φ59×9 pipe clamp assembly 1
6 1274200-079000 ZT310 water pipe clamp(φ9) 1
8 1251300-063093 Plywood M6×11×15(color Zinc) 7
9 1050954-009000 YH canister solenoid valve 1
11 1250303-010093 GB6177.1M6 (environmental color) 1
12 1224100-012000 ZT250-S carbon tank 1
13 1224300-005000 ZT350-V air filter 1
10 1244200-096000
ZT310-V canister electromagnetic valve inlet manifold
(Φ5×Φ11/Φ7×Φ13)
1
7 1244200-097000
ZT310-V canister solenoid valve vent manifold (Φ4×Φ
10/Φ5×Φ11)
1
Fig.2 INTAKE SYSTEM
COMPONENT
Air filter components 2
PROCEDURE:
●
Air filter assembly
Remove the air filter intake air temperature sensor
⑵
from the air filter. If the sealant falls off, it needs to be
plugged back to its original position. Remove the clamp
⑸
.
Remove the 3 bolts (1) from the 4# inner hexagon, respectively, and remove the air filter assembly from the
car. Need to constantly adjust the angle to take out.
Remove 7 pieces of clamp nuts
⑻
.
The oil accumulation pipe
①
and the water accumulation pipe
②
should be checked and cleaned regularly.
●
Carbon Tank Assembly
Use hoop pliers to remove the carbon canister and the 4 pieces of clamps (3) on the solenoid valve end of
the carbon canister, and then pull out the adsorption pipe
⑷
, the air outlet pipe
⑺
and the intake pipe
⑽
.
Remove all hoops .
Remove the carbon canister
⑿
.
●
Carbon tank electromangnetic valve
Remove the nut
⑼
with the 10# sleeve; remove the solenoid valve
⑺
.
●
Check the carbon canister solenoid valve:
In case of poor engine performance; Poor idle speed; If the air-fuel ratio is incorrect, check the carbon
canister solenoid valve.
Use a multimeter to measure the resistance between the two inserts of the carbon canister solenoid valve
plug, which should be 35 ± 2 Ω, otherwise the solenoid valve fault can be judged.
●
Check whether the temperature sensor is damaged
Remove the temperature sensor from the air filter and place it in the ambient temperature (20
～
30
℃
), and use a multimeter to check whether the resistance of the two pins is between 2726
～
1770 Ω.
CAUTION:
●
Remove the side cover,seat cushion,fuel tank,etc. in advance.
●
Regularly check whether the filter element of the carbon tank and air filter is not ventilated,
otherwise it may cause the oil supply to affect the driving experience.
●
It should be no crimp, entanglement and other phenomena.