Zontes ZT350-V1, Руководство по обслуживанию

Страница: 100 / 120

8
、
FUEL TANK COVER COMPONET
99
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251100-102000 Non-standard bolt M6×16 (304 stainless steel) 6
2 1274100-057095
Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5
6
3 1244100-052000 Buffer rubber of flanging bushing (φ8.5×φ14×1) 6
4 1224200-196000 ZT310-VX fuel tank decoration cover left grid 1
5 1251300-063093 Plywood M6×11×15(color Zinc) 4
6 1174200-052000 ZT310-VX front left turn signal 1
7 1251200-038093 Non-standard self-Tapping screwST3.9×12(Zinc) 4
8 1224200-197000 ZT310-VX fuel tank decoration cover right grid 1
9 1174200-051000 ZT310-VX front right turn signal 1
Fig. 7 FUEL TANK COVER
COMPONET
Fuel tank trim cover assembly 4
PROCEDURE:
●
Fuel tank decoration cover, turn signal, grille
Use a 4# inner hexagon to remove the bolt
⑴
at a, and remove the bush
⑵
and the cushion rubber
⑶
.
Loosen the bolt
⑴
with a 4# inner hexagon socket b and remove the 2 self-tapping screws
⑺
with a cross
screwdriver. Remove the left grid
⑷
of the decorative cover. Remove 2 pieces of splints
⑸
from the left grid
⑷
.
Use 4# inner hexagon to remove bolt
⑴
at b, remove bushing
⑵
and cushion rubber
⑶
, and remove left
turn signal
⑹
. Note that the turn signal uses 4 buckles as indicated by the arrows in Figure 1.
Remove the right grid
⑻
and the right turn signal
⑼
according to the above steps.
CAUTION:
●
The parts should be protected during the disassembly process to prevent damage to the paint surface.
●
When removing the buckle, pay attention to the strength to prevent damage to the buckle.
●
When recovering, the screw
⑺
should make the screw axis perpendicular to the installation surface, and
can not be tightened too tightly to prevent damage to the pin on the grid.