Zontes ZT350-V1, Руководство по обслуживанию

Страница: 9 / 120

1
、
FRAME COMPONENT
8
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1184300-007000 ZT350-VX wiring harness assembly (A) 1
2 1224100-030000 Pin tie (Black 4.8×130) 2
3 1224100-037000 Grade 0 flame retardant tie (black 3.6×295) 3
4 1244200-103000 ZT310 relay rubber sleeve 5
5 1244100-082000 ZT250-R dump switch sleeve 1
6 1184100-002000 ZT250-S dump switch 1
7 1180300-101000 HJ150-3 square flasher (LED) 1
8 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 5
9 1224200-205000 ZT310 electronic cushion lock block 1
10 1274100-058000 ZT310 Electric seat lock 1
11 1184100-010000 ZT250-S starting relay 1
12 1184100-017000 ZT250-S fuel-injection relay 5 KH-1A4T
13 1224300-110000 Reverse buckle Velcro strap (20×200mm) 8
14 1224300-111000 Reverse buckle Velcro strap (20×300mm) 2
15 1224300-093000 Reverse buckle Velcro strap (20×150mm) 5
16 1251100-102000 Non-standard bolt M6×16 (304 stainless steel) 1
17 1274200-171000 ZT310-V relay bracket 1
18 1251300-085093 Non-standard cap nut M6 2
20 1274200-268000 ZT310-VX Bosch ECU bracket 1
PROCEDURE:
●
Flasher and dump switch
Remove the rubber sleeve that connects the flasher
⑺
to the mounting bracket on the frame, and remove
the dump switch with the same method, then separate the dump switch sleeve
⑸
.
●
Relay and ECU
Pull out the rubber sleeve (4) on the right side of the frame and then pull out the EFI relay (12). Find the
starting relay (11) above the air filter, pull off the sheath of the harness, remove the self-contained nut and
remove the relay from the relay support (18). Remove the bolt (14) with 4# hexagon socket and remove the
bracket (13). Unplug the plug of the engine controller
⒄
on the left and remove the nut (16) with a 10# sleeve.
Remove 2 bolts (8) with 4# socket head and then remove ECU bracket (18).
●
Seat lock
Take off the plug of the seat lock , and cut off binding
⑶
. Use a 4# inner hexagon to remove the front bolt
⑻
, and remove the guide block
⑼
; remove the 2 rear bolts and remove the electronic cushion lock
⑽
.
Fig.1 FRAME&ELECTRONIC PARTS
COMPONENT
Electronic parts COMPONENT-1
●
Main harness
Different plug-in methods are different, please unplug all the electrical components connected to the
main thread according to the actual operation. It needs to use a screwdriver, forceps, scissors and
other tools to assist.The binding
⑶
can be picked out by using scissors.
CAUTION
：
●
Please notice the limit of the bracket when dismantling flasher and dump switch sleeve, beware of
hurting your fingers.
19 1050958-014000
MSE6.0 controller-ZT184MP (matching split sensor/
Euro V)
1