Zontes ZT350-V1, Руководство по обслуживанию

Страница: 10 / 120

1
、
FRAME COMPONENT
9
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251112-001093 M6×16 Hexagon flange bolts (color zinc) 1
2 1274300-065000 ZT350-VX front oil pipe bracket 1
3 1184200-004000 ZT310 horn 1
4 1274100-017000 ZT250-S cable buckle 2
5 1224100-037000 Grade 0 flame retardant tie (black 3.6×295) 2
6 1274100-095000 ZT250-S Flameout switch wire fixing bracket 1
7 1184100-012000 ZT250-S shut down switch 1
8 1250205-040095 GB70.1 inner hex bolt M8×16(color Zinc) 2
9 1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color zinc) 3
10 1251112-002093 M6×30 Hexagon flange bolts (color zinc) 1
11 1274300-067000 ZT350-V Water outlet pipe anti-wear bracket 1
12 1186200-013000 ZT310 Rectifier (350W) 1
13 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 1
14 1274300-064000 ZT350-V1 ignition coil bracket 1
15 1050958-006000 ZT350 ignition coil body 1
16 1050958-007000 ZT350 EFI high voltage line 2
17 1224300-110000 Reverse buckle Velcro strap (20×200mm) 1
CAUTION
：
●
Do not pull the cable hard when removing the sub-mud switch.
●
The replacement of the spark plug and the matters needing attention are described in the
instruction manual.
PROCEDURE:
●
Horn
Take off the plug of horn take the horn
⑶
by one hand, using 8# plum wrench rotate the screw
⑴
by
another hand remove the holder
⑵
then take off the horn.
●
Flameout switch
Find and take off the plug of the flameout swich
⑹
press and take off the cable clip
⑷
cut ribbon
⑸
.Using
the 6# inner hexagon tool, remove the bolts
⑻、
the holder
⑹
and the flameout switch
⑺
.
●
Rectifier
After unfastening the tie strap
⒄
then find and remove the rectifier plug, Using 8# sleeve remove the bolt
⑽
, remove the outlet pipe bracket
⑾；
Using 8#sleeve remove the bolt
⑼
and remove the rectifier
⑵
.
●
Ignition coil
Pull out the high-voltage wire (16) then end of the spark plug, pull out the end of the ignition coil body and
remove it. Remove the bolt (9) with 8# sleeve and remove the ignition coil body (9). Then using 4# hexagon
socket remove the bolt
⒀
and remove the high-pressure package support (14).
Fig.2 FRAME&ELECTRONIC PARTS
COMPONENT
Electronic parts COMPONENT-2