Zontes ZT350-V1, Руководство по обслуживанию

Страница: 67 / 120

7
、
FRONT FORK COMPONENT
66
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1100100-833000 ZT350-GK front brake lever (machine addition) 1
2 1100100-831000 ZT350-GK front disc main pump assembly
（
φ14
）
1
3 1251513-013000 Disc brake pipe copper washer φ 15× φ 10.2 × 1.5 2
4 1251100-112000 Disc brake pipe bolt M10×1-22 1 32N·m
CAUTION:
●
The motorcycle should be fixed after horizontal support and check.
●
Periodically check that the fluid level of the brake fluid is at 3/4 of the observation window.
●
If the liquid level is under "LOWER", check the brake disc wear and brake system for leaks.
●
If you swallow the brake fluid, contact poison control center or hospital immediately; if you get into
your eyes, seek medical attention immediately after flushing with clean water.
●
Keep brake fluid away from children and pets.
●
Do not flush the cup directly with high-pressure water.
●
Do not mix water, dust, impurities, and silicic acid or petroleum-based liquids, as this may cause
serious damage to the brake system.
Fig.6 FRONT FORK
COMPONENT
PROCEDURE:
●
Front disc brake main pump
Fix the front disc brake main pump, remove the bolt
⑷
and copper pad
⑶
with a 12# sleeve, and do not
disassemble if it does not need to be replaced. Always replace the tubing connector
⑧
at a high level to
prevent air from entering the tubing and cause brake failure. Also clean oil should be removed to prevent
dripping onto parts such as covers or mufflers. After replacement, be sure to hold the handle
⑴
continuously
and tap the main pump
⑵
of the disc brake at the same time to eliminate a small amount of gas entering the
brake oil circuit and confirm that the braking returns to normal.
●
Handle
Rotate the adjusting nut
⑤
to adjust the distance between the handle and the handle rubber sleeve to adapt
to the hand feeling of different drivers.
If the handle needs to be replaced, fix the bolt
④
with 5# inner hexagon socket tool, and then remove the
nut
⑥
with 10# sleeve or double offset ring spanner; Remove the bolt
④
and then remove the handle
⑴
.
●
Add brake fluid
Before driving the motorcycle, check whether the brake fluid level is above the “LOWER” marking. If not,
check the brake disc or brake disc for wear and whether there is any oil leakage or oil leakage in the brake
system. Abnormal needs to add brake fluid.
The brake fluid can only be added after the motorcycle is fixed horizontally.
Remove the bolt
①
with a Phillips screwdriver and remove the upper cover
②
, the cover plate
③
, and the
seal gasket
⑦
.
Add DOT4 brake fluid to 3/4 of the transparent observation window of the front disc brake master pump.
Be sure to clean the foreign body before reassembling it.
Add brake fluid, rocker adjustment