Zontes ZT350-V1, Руководство по обслуживанию

Страница: 117 / 120

13
、
MUFFLER COMPONENT
116
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1224300-088000 ZT350-V1 EFI relay holder 1
2 1250105-148093 GB70.1 inner hexagonal M8×35 (color Zinc) 1
3 1251112-002093 M6×30 Hexagon flange bolts (color zinc) 1
4 1251112-003093 M6×45 Hex flange surface 9.8 bolt (color zinc) 1
5 1251300-058093 Inner hexagonal nut M8 (color zinc) 2
6 1020243-098000 ZT350 muffler gasket (φ8.3×φ33×1.5) 2
10 1250205-093093 GB70.1M8×40 (environmental color zinc) 1
11 1250303-011093 GB6177.1M8(color zinc) 1
Fig.1 MUFFLER
COMPONENT
Muffler component 1
PROCEDURE:
●
Muffler assembly
Hold the fixing seat
⑴
with one hand on the inner side above the right guard bar, pull the oxygen sensor plug
in the direction of the arrow with the other hand, remove the plug from the fixing seat, and then pull out the
plug.
Remove the radiator grill referring to "Radiator grill" in the chapter on cooling system components. Refer to
the fuel tank assembly to remove the fuel tank trim cover assembly. Loosen the bolts
⑶
and
⑷
on both sides
of the main water tank with an 8# sleeve, push the radiator assembly forward to expose 2 pieces of nuts
⑸
,
and then remove them with a 6# inner hexagon.
Remove the bolt
⑵
in the middle of the muffler with a 6# inner hexagon. In order to facilitate the next
operation, this bolt needs to be manually screwed back for about 5 turns.
Use a 13# Torx wrench to fix the nut
⑽
on the back and remove the bolt
⑼
with a 6# hexagon socket on the
outside.
After supporting the front elbow and rear section of the muffler assembly, remove the bolt
⑵
in the middle,
and remove the washer
⑹
.
Remove the muffler assembly.
CAUTION:
●
The material should be protected during disassembly to prevent damage to the paint.
●
The muffler should be completely cooled before it is disassembled.
8 1020243-097000
ZT350 muffler flanging bushing (φ8.3×φ11.5×20.5×φ
8.4×φ33×1.5)
2
7 2 1244300-022000
ZT350-GK-H1 muffler suspension hollow cushioning
rubber