11-REAR COVER COMPONENT
74
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
5
2
1274100-057095
Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5
5
3
1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
5
4
1224100-010000 ZT250
－
S swell nail
1
5
1251100-101000 Non-standard bolt M6×12
（
304 stainless steel
）
2
6
1244100-006000 ZT250
－
S rear liceness rubber buffer
1
7
1221200-068000 KD150
－
G1 rear license plate bracket
1
8
1271200-177000 KD150
－
G1 rear mud board bracket (integrated)
1
9
1174100-002000 ZT250
－
S rear reflector
1
PROCEDURE:
●
Rear fender assembly
Use 4# inner hexagon to remove the 2 bolts
⑴
in Figure A, remove the flange bushing
⑵
, cushion rubber (3),
and remove the expansion nail
⑷
.
Use 4# inner hexagon to remove bolt
⑸
,find the plugs of the rear lights, turn signals and license plate lights at
left rear tail cover and unplug them.
Use a 4# inner hexagon to remove the 3 bolts
⑴
in Figure B, remove the flange bushing
⑵
and cushion rubber
⑶
and remove the rear license plate bracket from the rear fender bracket. Pull out the cushion rubber
⑹
from
the rear license plate bracket
⑺
.
Use a 10# torx wrench to remove the nut
③
and washer that come with the rear reflector
⑼
, and remove the
rear reflector and the rear fender plate bracket
⑻
from the rear fender plate component.
CAUTION:
●
The motorcycle should be fixed before operation.
●
Cushion can cause accidents if it is not installed properly.
●
Pay attention to the lamp connector, do not insert the wrong, turn left Green + orange; right turn signal is green
+ blue; license plate light is green + pink.
●
When reassembling, check whether there is any pressure on the wire to prevent short circuit when tightening
the bolt.
Rear mud board assembly 1
Fig.4 REAR COVER
COMPONENT
