7-FRONT FORK COMPONENT
48
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
6
2
1274100-057095
Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5
2
3
1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
2
4
1251200-033093 Non-standard self-tapping bolt ST4.2×12(color zinc )
1
5
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
2
6
1224100-010000 ZT250
－
S swell nail
6
7
1251300-063093 Plywood M6×11×15
（
color zinc
）
2
8
KD150
－
GK meter decorative cover
1
Fig.11 FRONT FORK
COMPONENT
Head and headlights component 1
PROCEDURE:
●
Headlight assembly
Remove the 4 bolts
⑴
in Figure A and B with 4# inner hexagon, then pull out all the plugs, and remove the
entire head.
●
Meter decorative cover , Left and right turn signal components
Remove the 2 bolts
⑴
in Figure C with 4# inner hexagon, take off the flange bushing
⑵
, the cushion rubber
⑶
;Use 5# hex socket to remove self-tapping bolt
⑷
. then remove the 2 bolts
⑸
in Figure D with 4# inner
hexagon,remove the 2 expansion nails
⑹
in Figure E,finally remove the 4 expansion nails
⑹
in Figure F, remove
the meter decorative cover ,and turn signal components.
CAUTION:
●
Pay attention to the force when removing the cable and unplugging the plug and the cable to avoid damage.
●
The head unit should be supported during the disassembly process and protective measures should be taken
toprevent scratching the lamp cover or paint surface.
●
Figure a is the unmounted state; Figure b is the assembled state; Figure c is the disassembled state.
●
When assembling self-tapping screws must be perpendicular to mounting surface, otherwise it will
bedamaged,and the torque should not be too large.
