9-FUEL TANK COMPONENT
67
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
2
2
1274100-057095
Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5
2
3
1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
2
4
1184200-002000 ZT310 electronic fuel tank lock
1
5
1224100-033000 ZT250
－
S threaded fuel tank cap
1
6
4041201-381051 KD150
－
GK fuel tank middle cover
1
7
4041201-382051 KD150
－
GK fuel tank outer cover
1
Fig.3 FUEL TANK
COMPONENT
Fuel Tank middle cover assembly
PROCEDURE:
●
Fuel tank middle cover component
Use 4# inner hexagon to remove bolt
⑴
,take off the flanging bushing
⑵
and buffer rubber
⑶
.
Remove the fuel tank cap,be careful not to pull the nylon cord
①
hard.
Push forward from the fuel tank middle cover tail,lift tail up slightly after 4buckles
④
loosens,shake and push
until the bickle is out of the slot,but don't remove the fuel tank middle cover
⑹
.
Remove the cables on the clip
⑤
.
Put the fuel tank cap
⑸
back into the fuel tank to prevent fuel volatilization and foreign matter from falling into
the tank.
●
Fuel tank lock
Use a flat-blade screwdriver to carefully pry the ends of the middle cover
⑹
and remove the fuel tank lock
⑷
,
taking care to prevent damage to the buckle.
●
Fuel tank cover assembly
Use a needle-nose pliers to clamp the buckle of the swivel bracket with a little force to clamp, remove the cover
assembly, and take care of the strength to prevent damage.
CAUTION:
●
The fuel tank should be protected during the disassembly process to prevent damage to the paint surface.
●
Pay attention to the force when removing the buckle to prevent damage to the buckle.
●
Fireworks, telephone calls should not be allowed near the motorcycle -removal workshop to prevent
accidents.
