This is to protect the blower motor from overheating
during extended operation. To change the
ON
time from
the default value of 30 minutes, refer to the DEVICE
RUNTIME feature.
Fill Line
When an AUX button labeled “Fill Line” is pressed,
it will turn on the fill line for 30 minutes, and then
automatically turn it off. A fill line may be programmed
like any other auxiliary, except that you can program
only the
ON
time. The fill line will turn on at the
programmed
ON
time, and turn off 30 minutes later.
This is to avoid overfilling the pool. Choose the
appropriate number of "fill" programs during the week
to keep your pool at the appropriate level. To change the
ON
time from the default value of 30 minutes, refer to
the DEVICE RUNTIME feature.
14.3 Controller Messages
CLEANER CANNOT BE TURNED ON WHILE
SPA IS ON
This message is displayed if the pool cleaner is
activated when in spa mode (i.e., water is circulating to
spa). The pool cleaner requires that water be circulating
to the pool in order for it to operate. Return to pool
mode to activate the cleaner.
CLEANER CANNOT BE TURNED ON WHILE
SPILLOVER IS ON
The return valve has been rotated to the spa position to
give the spa spillover effect.
FREEZE PROTECT
This message indicates that freezing conditions have
been detected by the freeze protection sensor, and that
equipment assigned to freeze protection (e.g., filter
pump) are active.
See Section 9.11,
"Freeze Protection"
.
NOTE
If a freeze protected Auxiliary is turned off during
freeze protection, a message will be displayed
indicating that item is off but will turn on in X amount
of minutes. The minutes will vary depending on
how long freeze mode has been active from 1 to 15
minutes.
SENSOR OPEN
This error message indicates that the sensor is not
installed properly or is malfunctioning. Call your pool
service person to resolve this problem.
NOTE
If the message reads WATER TEMP OPEN, the
heater will not fire. If message AIR TEMP OPEN is
displayed, freeze protection will not operate correctly.
POOL HEATER ENABLED
This message indicates that the pool heater is ready to
use but is not actually firing. The filter pump must be
on, and the water temperature must be below the setting
for the heater to fire.
PUMP WILL REMAIN ON WHILE SPILLOVER IS ON
This message is displayed when you attempt to turn
off the filter pump while a spa spillover is on. Since
the filter pump is necessary for spillover operation, the
pump will remain on until the spillover is turned off.
PUMP WILL TURN OFF AFTER COOL DOWN CYCLE
This message indicates that the filter pump is circulating
water to cool down the heater. The filter pump will
continue to run for five (5) minutes to protect the heater
from damage, whenever the heater has fired and has
been off for less than five (5) minutes.
PUMP WILL TURN ON AFTER DELAY
This message is displayed during pool/spa switching.
The AquaLink RS waits 35 seconds while the valves
turn from pool position to spa position (or vice-versa)
before activating the filter pump.
SERVICE MODE
This message indicates that the Controller has been
locked out from the power center and is not operational.
Service mode is used by the pool service person to aid
them in servicing the pool. The Controller will not be
functional until the switch at the power center is moved
back to AUTO mode.
Page 62
iAquaLink™ Web Connect Device for AquaLink
®
& PDA Control Systems
|
Owner's Manual
ENGLISH
