Ziton ZP2 Series, Руководство по установке

Страница: 19 / 148

Chapter 1: Introduction
ZP2 Series Installation Manual 13
Condition type Description
Loop device not configured A loop device is detected that is not configured
Maximum conventional zones
exceeded in a network
The number of conventional zones in a fire network
exceeds the maximum allowed
Maximum loops exceeded in a
network
The number of loops in a fire network exceeds the
maximum allowed
New node in the fire network A control panel has been added to the fire network
Output group activation An output group is activated
Prealarm A device (and corresponding zone) is in prealarm
Sounder, fire routing, and fire
protection delays
A sounder, fire routing, or fire protection delay is enabled or
disabled
Tests A control panel feature or device is being tested
[1] These condition types only apply if an extinguishing panel is included in the fire network.
In addition to the above, the following system status events are also added to the
event log (but are not included in the control panel current events report).
Table 8: Other system status events added to the event log
Event
Description
Actions An output group is activated or deactivated or a
programmable system command is executed (via the
Configuration Utility)
Conditions deactivation A system condition is deactivated
General system events The control panel is reset, the panel is silenced, a new date
and time is set, the system is initiated, etc.
Power supply faults eliminated A previously logged power supply fault is resolved
Rules activation A rule is activated [1]
User sessions The date and time information for activation and termination
of user sessions
[1] A rule consists of one or more states (combined by Boolean operators) that are configured to
trigger specific system actions after a specific confirmation time. Rules are created using the
Configuration Utility.