Ziton ZP2 Series, Руководство по установке

Страница: 84 / 148

Chapter 3: Configuration and commissioning
78 ZP2 Series Installation Manual
3. Press F4 (Enter), and then press F1 (Back).
4. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Autosetup will:
• Assign all initiating devices (including zone modules) to zone 1
• Assign all sounder devices to the default sounder output group (output group
number 1)
• Assign all nonsupervised outputs (relays) to the default program output group
(output group number 301)
• Assign all extinguishing devices to the default extinguishing output group
(output group number 801)
Extinguishing output groups are only activated with a confirmed alarm. They
are not activated by zone alarms and rules.
• Assign all fire routing outputs (where available) to the default fire routing
output group (output group number 971)
• Assign all fire protection outputs (where available) to the default fire protection
output group (output group number 981)
• Assign the default initial zone to zone 1
• Indicate the number of new devices added (by device type) after each scan
By default all zones activate all output groups with no delay.
Note: Autosetup is incremental and retains the device text description for
previously configured devices.
Loop device configuration
Select Loop device configuration to manually add devices or to change the
default configuration settings after autosetup.
To add a device or to change a device configuration:
1. Select Field setup from the Main menu, and then select Loop device
configuration.
2. Select the corresponding loop and device.
For new devices, a message is displayed.
3. Make the required configuration changes (device type, operating mode, text,
etc.).
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.