Ziton ZP2 Series, Руководство по установке

Страница: 122 / 148

Chapter 5: Technical specifications
116 ZP2 Series Installation Manual
Communication port specifications
Ethernet
Ethernet 10/100BaseT port (10 Mbps)
Note: For increased security, we recommend against using
Ethernet for remote connection to the control panel via the
Internet.
TCP/IP IPv4
USB host port USB 2.0, type A connector
USB device port USB 2.0, type B connector
Fire network specifications
Maximum distance between
two control panels
1.2 km
Maximum default capacity 32 loops and 32 nodes
Communication protocol Proprietary protocol based on RS-485
Input and output specifications
Input and output overview
Configurable
outputs
General fire
outputs
General fault
outputs
24V AUX
output
Configurable
inputs
One-loop panel 2 Class B
1 Class A
2 (see note) 2 (see note) 1 2
Two-loop panel 4 Class B
2 Class A
2 (see note) 2 (see note) 1 2
Two-loop panel with
loop board
8 Class B
4 Class A
2 2 1 2
Repeater panel 0 2 2 1 2
Note: 1 supervised output and 1 potential-free relay.
Configurable inputs [1]
Number of inputs 2 supervised inputs, end-of- line resistor 15 kΩ, 1/4 W
Active value 60.2 Ω ≤ active value ≤ 8 kΩ (0.33 to 15 VDC)
Standby value 10 kΩ ≤ value ≤ 20.2 kΩ (16.1 to 18.9 VDC)
Short circuit values ≤ 60.2 Ω (less than 0.33 VDC)
High-impedance fault value 8 kΩ < value < 10 kΩ (15 to 16.1 VDC)
Open circuit values ≥ 20.2 kΩ (> 18.9 VDC)
Configurable options See Table 48 on page 86
[1] All values based on 2.5 A max. at 24 VDC (Imax. a, system voltage).