Ziton ZP2 Series, Руководство по установке

Страница: 60 / 148

Chapter 3: Configuration and commissioning
54 ZP2 Series Installation Manual
Table 20: Control panel configuration
Option
Description
ID configuration Configures the control panel Firenet ID (for the fire network) and
description. The description is displayed on the LCD when the
control panel is in standby.
Date and time Configures the control panel date and time, and to synchronize the
date and time in a fire network. See “Date and time” on page 41.
Day/Night mode Configures the sensitivity settings for the day/night schedule and
for the holiday calendar. See “Day/night mode sensitivity settings”
on page 41.
Regional options Configures the control panel's regional operation mode.
Firenet Configures the control panel fire network.
Communications Configures TCP/IP communication settings, to manage email
accounts (for event notifications), and to safely remove a USB
device.
Other settings Configures general panel settings, including 24V AUX output, fault
mask, sounder re-sound, school bell settings, etc.
Load/Save configuration Loads a new configuration, saves the current configuration file to a
USB flash drive, restores the previous configuration, or restores the
default factory settings.
Expansion boards Configures any installed expansion boards.
Load auxiliary files Loads auxiliary files from a USB flash drive. Auxiliary files that can
be loaded include custom standby and alarm screens, and updated
language or font files for extended language support.
System update Loads control panel firmware updates.
Printer configuration Configures external and internal printer settings.
DACT configuration Configures Ethernet, central monitoring station, PSTN, and GPRS
settings for an installed DACT board.
Panel Activation Key Registers or unregisters panel activation keys (PAKs).
Auto Date and Time Configures additional date and time settings, including SNTP,
daylight saving, and time zone.
BMS Config [1] Configures building management protocol settings (BACnet ®,
Modbus ®).
[1] Use of BACnet or Modbus requires the corresponding PAK to be registered at the gateway
panel.
ID configuration
Select ID configuration to configure the control panel Firenet ID (for the fire
network) and description. The default ID is 001.
Note: The allowed ID range is defined by the size of the fire network. The default
range is 001 to 032, but the range increases if the size of your network is
extended using a panel activation key (PAK). See “Panel activation key” on page
75.