Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 29 / 50

S L R M I S S I L E
29
Use ½ inch ID silicone on the pipe end.
Pipe mount assembled. Top view.
Pipe mount in place on hull bottom.
Exhaust
Put the exhaust system on the engine.
The header should be cut so that there is
about 2 inches of header inside the pipe
with the pipe as short as it will go.
Use the Zipp 2008 water cooled flange
and remember that the O-rings go on
each side of the header flare.
Use blue Loctite on the flange bolts.
Adjust the pipe so that it is pulled out
about ½ inch from all the way in (14
inches).
Put the engine in place and tighten the
engine mount bolts.
Slip a piece of ½ inch ID silicone tubing
over the end of the pipe, and put the
rubber insert pipe clamp onto that.
Put the lock washer onto the ¼-20x1 inch
screw and slip it through the clamp.
The screw goes through the slot in the
pipe mount, and the nut plate goes in the
back of the pipe mount.
Put the pipe mount about halfway in the
slot.
Tighten this assembly so that it is snug
and rotate the pipe mount so that it sits
flat on the hull bottom.
Do not pull the pipe to either side, as this
can cause the pipe to crack.
Glue the pipe mount where it sits with
epoxy.
Allow to cure.