Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 18 / 50

S L R M I S S I L E
18
We should go into the clamp business!
Front of sponson bottom beveled for nice
transition.
Do whatever you need to for a good glue joint.
Overhang of ride pads.
Sponson Bottoms
Bevel the front of the forward sponson
bottoms (not marked, and R) so that they
will transition nicely into the bottom.
This bevel will be on the outside of the
bottom.
It is much easier to do this now.
When happy with the fit, glue in place the
rear sponson bottom (not marked, and R).
At the same time, glue in the forward
bottom. Overlap the forward bottom onto
the rear by about 1/16 to 1/8 inch.
Make sure that the bottoms are aligned all
the way around and clamp, weight and
tape in place until cured.
Note that the rear bottom should overhang
the sponson by about 1/16 inch.
Leave this in place. Don’t sand it off.
Keep rear overhang.