Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 24 / 50

S L R M I S S I L E
24
Radio box spacers in place.
Sealing seams of radio box.
Engine rails are pre-drilled for Zipp 3409 mounts.
When cured, glue the radio box spacers
(RS) to the bottom of the radio box.
When cured, sand the entire box with 180.
Stand back and admire your awesome
radio box!
Seal Radio Box
Remove everything from the radio box,
and coat the inside and outside with
finishing resin.
Be careful not to get any buildup in the lip,
where the lid seats. It will make it
impossible for the lid to seal properly. To
get inside the upper part, bend an acid
brush about 120 degrees, this works very
well.
You can seal the inside, top and all four
sides of the outside in one session.
Allow to cure overnight.
Apply a second coat of sealer.
Tip: To make sure that the radio box stays
100% free of water, seal the seams.
To do this, use an acid brush and 30
minute epoxy.
Brush on a coat of epoxy to all inside
seams. Bottom to sides and side to side.
Allow to cure for a couple of hours, then
do the same thing with the top to side
corner.
Lay the box upside down and allow to
cure.
Sand the top of the box with 220 grit or
finer, so that the sealing tape has a
smooth surface to adhere to.