Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 39 / 50

S L R M I S S I L E
39
Do whatever necessary to clamp 100%.
Deck center fitted and glued.
Sponson deck being glued.
You can clamp to the sponson deck
supports (SDS) near the front.
Tape the crap out of the deck, make sure it
is completely attached, allow to cure at least
3 hours and repeat the procedure on the
other side.
Make sure the hull stays weighted on the
bench until all decks are cured.
Glue the 3/16 dowel to the front of the cowl.
Do not glue the cowl to the boat!
Once all decks are cured, fit and glue in the
deck center with 30 minute epoxy. The deck
center should cover the deck center support
glued to bulkhead 1.
Tape tightly in place. Let sit for at least 3
hours.
We used a couple of clamps made from 3
inch PVC pipe, sliced into rings about an
inch wide with about 1 inch cut out.
Sand the tops of the bulkheads and DS
parts. Bevel the forward non trip sheeting to
accept the sponson decks.
Glue the sponson decks on the same way.
Test fit the decks into the 1/16 slots. Adjust
the tabs as needed.
Try to get a nice tight fit with the sponson
decks.
You can cut the top center of all bulkheads
(2, 3, 4 and 5) off at this point. Cut just to the
deck supports. Sand and seal the cut areas.
Mix up some 30 minute epoxy and pour it
into the nose to create a strong joint. Do
this for all three pieces at the nose.
Makes the boat less likely to split when
you hit something
…