Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 40 / 50

S L R M I S S I L E
40
Drilling cowl former 1/8 inch.
Drill transom only to 13/64.
Latch pressed in. Don’t glue until paint.
Cowl Latch
Put the cowl in place and drill a 1/8 inch
hole where marked on the transom.
Drill through the transom and the rear
cowl former.
Hold the cowl down and drill slowly.
Remove the cowling and drill the hole in
the transom ONLY to 13/64 inch.
The latch should go all the way in until the
body is almost flush on the inside of the
transom.
This gives the latch maximum penetration
into the cowl former.
Test the fit of the hatch latch, but do not
glue in until the boat is painted.
Latch installed, but not glued.