Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 16 / 50

S L R M I S S I L E
16
Rear non-trips in place. Right and left are the
same.
Rear non-trip taped tightly in place.
Sanding for sponson non-trip.
Rear Non-Trip
Check the fit of the rear non-trip pieces.
You will probably need to bevel them very
slightly near bulkhead 4. Use your
sanding block with 80 grit to break the
edge of the non-trip near BH4.
There will be a gap at the front, and a
small notch at the rear that will require
filling.
When happy with the fit, glue in place.
Tape tightly and allow to cure.
Forward Non Trip
Using your razor plane and 80 grit
sanding block, sand the spray rail and
outer chine so that the non-trip sheeting
will lie flat.
Go all the way onto the bottom sheet, as
far as the outer chine goes.