Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 12 / 50

S L R M I S S I L E
12
Side stringer being glued in place. Note clamps.
Side stringers flush with bulkhead edge.
Wood clamped to transom to keep it straight.
Be sure that the stringer with cooling slots
goes on the side opposite the two holes
(opposite side from the turn fin). These
cooling slots help cool the tuned pipe, and
should be retained.
Clamp at bulkheads 4 and 5, and tape the
rear corners tightly.
Before the glue dries, check to be sure that
the stringers are lined up with each forward
bulkhead (1, 2 and 3). See picture.
This is mainly cosmetic, but it will make it
easier to install the sponson decks later.
When cured, glue the transom (T) to the
back of bulkhead 5.
Center it so that it if flush at the top and
bottom, as well as both sides.
The bevels will not line up.
Clamp well and allow to cure. We like to
clamp a piece of straight wood or metal to
the transom while laminating it to bulkhead
5.