Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 19 / 50

S L R M I S S I L E
19
Epoxy/ micro balloons filler on rear non-trips.
Same filler at front sponsons.
Fill and Sand
Use 30 minute epoxy and filler (micro
balloons work very well) to fill the gaps at
both rear non-trips, as well as any gaps
on the hull.
Mix the micro balloons so that the mixture
is like stiff toothpaste. Almost dry
consistency. Work quickly.
Use a piece of scrap wood as a spatula to
apply.
Don’t worry if it’s not pretty. We are going
to sand most of it off anyway.
Also apply this filler mixture to the corner
where the bottom meets the front
sponsons.
Make a nice small fillet. Dip your finger in
denatured alcohol and smooth it as much
as possible.
Wipe off as much excess glue as
possible.
Allow to cure overnight.
Sand all filler and rear non-trips with 80.
Sand the 1/16 sponson non-trip sheeting
flush with the spray rail.
Use a piece of tape on the sponson chine
to protect it from the sanding block.
Sand the hull with 80, then 180 or 220.
Cut the tabs holding the hull to the jig.
Be careful not to cut too close to the hull.
Cut low, near the jig.
Stand back and admire your awesome
new Thunderboat hull!
I’ll bet that is was not nearly as difficult as
you thought!