Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 21 / 50

S L R M I S S I L E
21
Cowl deck support parallel with side.
Cowl deck supports glued in place
Sealing the underside of decks.
Deck Supports
Bevel one end of the deck supports so
that they meet the front bottom sheet
squarely.
Measure the distance from the side stringer,
and mark the bottom so that the deck
supports will be parallel to them.
Glue these in place starting at the front.
Start about ¼ inch back from the front
edge and glue to each bulkhead.
Do this all the way back to bulkhead 6.
We recommend that you use epoxy and
clamp in place.
Also install the deck center support
(DCS) to the FRONT of bulkhead 1.
This will provide a gluing surface for the
deck center.
Seal Decks
Place the sponson decks and hull decks so
that they are mirror images of each other.
Mark these sides as the inside.
Mark one side of the deck center as well.
These will be the undersides of the decks,
and we need to apply 2 coats of resin to all
of them.
Mix up about 2 ounces of epoxy finishing
resin as before. Use a scrap piece of wood
as a squeegee to apply a very thin layer.
Look at the decks from different angles to be
sure that you didn’t miss any spots.
Scrape off as much resin as you can.
Allow to cure.
Once cured, scrape with a NEW utility knife
blade until smooth.