Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 27 / 50

S L R M I S S I L E
27
Servo mounts bolted to bottom.
Throttle servo in position. Note EZ connector.
Cut7-1/2 inches from the 4-40 pushrod.
3/16 dowels sanded to fit.
Radio
Install the Zipp 3422 Pro pushrod seal
aluminum bezels in the radio box.
Assemble both aluminum servo mounts.
Put them into the radio box and attach to
the bottom with the included brass flat
head screws.
Install an EZ connector to the throttle
servo arm. Install on the underside of the
arm, and use the metal retainer, not the
plastic one.
Screw a 4-40 ball link to your rudder servo
arm. Select a position that puts the
pushrod near the top of the (pushrod seal
aluminum bezel) hole.
Make up the 4-40 rudder pushrod.
We used 5/16 OD carbon tubing.
Cut the 4-40x12 inch pushrod in two
pieces. Cut 7-1/2 inches from the un-
threaded end.
Put a small 90 degree bend in the ends
(non- threaded ends).