Zippkits SLR Missile Thunderboat, Инструкция по сборке

Страница: 31 / 50

S L R M I S S I L E
31
Strut and rudder mounted to transom.
Notice two large screws and nuts on rudder.
Rudder pushrod in place.
Hardware
If using Zipp hardware, finish drilling the
holes in the transom with a 5/32 drill bit.
If you use optional blind nuts and 6/32
screws to attach the hardware, use a 3/16
drill.
Assemble your strut to the bracket.
Mount the rudder on the left side of the
transom. You will have to flip the rudder
over and drill out the small hole to 5/32
and use a 6-32 screw and nut.
We drilled a new hole so that we could
keep the rudder at 90 degrees to the
bracket.
Drill the rudder pushrod hole in the
transom with a ¼ inch bit.
Locate the radio box as close to bulkhead
3 as you can.
Leave at least 3/8 inch of space between
the tuned pipe and radio box.
Put the unthreaded end of the rudder
pushrod through the hole in the transom,
and into the rudder pushrod connector.
You may need to drill out the connector to
fit the 4-40 pushrod. If so, use a 3/32 bit.
Also remove the set screw when drilling.
Mark the location of the radio box on the
hull bottom.
Remove the rudder.
Adjust the strut so that the bottom of the
boat is 1-1/4 inches off the bench.
Strut flat on the bench with boat sitting on
front sponsons.
Tighten the strut.