Zimmer Biomet Zfx EvolutionNEXT, Руководство пользователя

Страница: 51 / 66

51
Please notify
Zfx Support of any malfunctions which cannot be rectified with the help of the information contained in the table below
Contact information can be found in the
→
Chapter entitled “Support Service”.
8.1 Fault finding
Problem Description/Cause Remedy
Program does not start
Error message:
“ OPCAT Message 6171:
OPCAT licensing: wrong coded informations ( Error ) !“
Switch on the scanner
Check the mains connection
Restart Zfx Manager 2.0
Calibration
unsuccessful
Error message:
Several marks could not be read.
Check calibration plate for damage.
RMS value > 12 µm Contact service engineer
Surface not detected or
holes in the scan image.
A surface could not be scanned in spite of optimal
alignment and illumination Use Zfx anti-reflection spray.
Change the position of the model.
Malfunctioning of the
scanner due to
incorrect location
Unit becomes very hot
Check that minimum distance from wall is 0.25 m.
If appropriate, avoid direct sunlight.
Fuse blown
Condensation
Short circuit When replacing the fuse, follow the instructions
in
→
Chapter 9.2.
Sensor unit
out of adjustment
The sensor unit can go out of adjustment if the
working temperature differs significantly from
15 °C to 30 °C.
Calibration shows a strong deviation in accuracy.
Always wait until the device has reached room
temperature (15°C to 30°C) and is absolutely dry.
Contact service engineer.
Software message:
“Code mark on
Zfx Synchronizer”
The code marks cannot be read by the program.
Check code marks for damage or contamination.
Repeat the detection process. If the code marks are
still not recognized, contact your service engineer.
Scan process
aborted
Scanner stops suddenly during the scanning process
Check the power supply
Restart the program
CAUTION
Do not spray Zfx anti-reflection spray inside the system. Always remove the scan object from the scanner before
spraying as otherwise there is a risk of the optical components being contaminated.
8 Operating faults